Rubber Roof Drainage Outlet - Rear Duct

Two types of drainage outlet suitable for use with flat roof or pent log cabins. These are particularly useful for when using EPDM or Esy Roof membrane. Used to create a hidden outlet from a dished roof.

When fitting a rubber roof there are two main ways it can be formatted, One of them requires an outlet like ours and the other does not.

1. Lay and wrap the EPDM up and over all four sides to create a four sided "bowl", Then cut a hole and fit an outlet like this to allow water to drain down and through a downpipe attached underneath. For this option consider the size of your roof and if more than one outlet is appropriate. for larger roofs with a total span of over 5m i would consider a second outlet point.

2. Only dish the EPDM up and around the front three sides to create a three sided "bowl", The rubber is then wrapped around and under the back roof overhang, in this situation an outlet is not required.

Features:

• Easy exit and connection to a drainage system.

• Glued to EPDM or Easy Roof Membrane.

• Made from EPDM rubber and plastic

P020960 Roof Duct - Round

• Can be placed anywhere on the roof to collect water, the pipe runs straight down.

P020962 Gromet Duct

• Slightly Slanting

• Best suited for our larch buildings or where a roof fascia has been raised for aesthetics.

• Protrudes from the fascia to the rear of the building.

Please Note: All outlets are glued using bitumen or EPDM glue. Approximate Delivery Time: 14 - 21 Working Days